Knitting Quality Development

Loop Length for a Target Finished Weight, Through Finishing Shrinkage

Set the loop for the finished fabric. The greige weight is a consequence, not a target.

Finished Specification What the customer buys, at the density it is measured at
g/m2
/cm
/cm
tex
Finishing Movement How far the fabric shrinks between the machine and the roll
%

Relaxation plus compacting

%

Loop Length to Set

— mm

Solved at the finished stitch density

Greige Expectation & Finishing Gain

Greige Weight to Expect
— g/m2
Weight Gained in Finishing
— %
Tightness Factor at This Loop
—
Greige Courses
— /cm
Greige Wales
— /cm
Area Shrinkage
— %
Finished Stitch Density
— /cm2
Greige Stitch Density
— /cm2
Yarn in a Square Metre
— m

The shrinkage figures are properties of a quality on a finishing route, not of a fabric type, and must be established from measured greige and finished samples rather than assumed - they drift with relaxation time, compactor setting and moisture. Weight gain in finishing is not independent of them: it is the reciprocal of the area factor, so if a measured gain contradicts the measured shrinkages, one measurement is wrong. This is a single jersey relation as written; on rib and interlock the stitch density must count loops on both beds or the calculated loop length will be out by a structure-dependent factor of around two. The finished density should come from a conditioned, fully relaxed laboratory sample - a density taken from fabric still under roll tension will produce a loop length that misses the target weight in the light direction. Residual shrinkage after laundering is a separate specification and is not addressed here.

Loop Length for a Target Finished Weight, Through Finishing Shrinkage — free, with the formula and a worked example, at Textile School.