Paramount Instruments 100mm Needle Detector Machine is a fabric inspection and rolling machine used in textile testing and quality control, still in its builder’s current range. Its builder lists belt speed 25-35 meter/minute, detecting height 100 mm, 35 1/2 In and length 1650 mm, 65 inch. It runs fabric over a lit inspection table, or past automatic camera systems, so that defects can be marked and graded, and then rolls or folds the fabric while measuring its length.
Fabric inspection and rollingTesting and laboratoryIn the builder's current range
Key specifications
Specifications incomplete: 0 of 3 key figures recorded
- Inspection speed (max.)—
- Working width—
- Roll diameter (max.)—
Specification
| Parameter | Value |
|---|---|
| Detecting Height | 100 mm, 35 1/2 In |
| Belt speed | 25-35 meter/minute |
| Length | 1650 mm, 65 inch |
| Depth | 1050 mm, 41 Inch |
| Digital auto counter with ferrous sensitivity | 1.0 mm |
Read from the builder's published page: www.paramountinstruments.in, on 2026-11-16.
Check against the machine before you buy or budget on it. Builders publish a range and a configuration; the machine on your floor may be a different variant, may have been rebuilt, and may not carry the options these figures assume. This register records what the builder published, not what any individual machine does.
The record
- Read from
- www.paramountinstruments.in,
- Checked by
- Textile School,
- Last changed
Related machines
Also from Paramount Instruments
- Paramount Instruments Beesley Balance / Yarn Count Tester i9 (Manual)
- Paramount Instruments Bursting Strength Tester i9 (Digital, 40kg)
- Paramount Instruments Bursting Strength Tester i9 (Pneumatic, 70kg)
- Paramount Instruments Button Snap Pull Tester i9
- Paramount Instruments Check Master B PR i9
- Paramount Instruments Check Master B PR P
Other machines of this kind: Fabric inspection and rolling
Report incorrect information on this page
Tell us what is wrong and we will check it against the source. Reports are private, are never published, and go to an editor rather than into a comment thread.