- Class
- Digital textile printing
- Process stage
- Dyeing, finishing and printing
- Lifecycle
- In the builder's current range
Specification
| Parameter | Value |
|---|---|
| Printhead technology (喷头技术) | 4–15 KM1024I/6pl greyscale printheads |
| Standard output (标准输出) | 100 m²/h |
| High-precision mode (高精度模式) | 73 m²/h |
| Backlit mode (背打灯模式) | 54 m²/h |
| Output resolution (输出精度) | Up to 726 × 1440 dpi |
| Colour configuration (颜色配置) | Standard 4 colours, white optional |
| Ink tank configuration (墨桶配置) | 2.5 litres per colour |
| RIP software configuration (RIP软件配置) | Photoprint 12, Caldera 11 & Onyx 12 (optional) |
| Rigid board specification (板材规格) | 330x250cm |
| Roll media specification (卷材规格) | Roll media up to 330 cm wide, 40 cm diameter and 100 kg |
| Media thickness (介质厚度) | 51mm |
| Data interface (数据接口) | USB 3.0 |
| Machine (机器) | 600x155x160cm |
| Packing case (包装箱) | 586x187x206cm |
| Temperature (温度) | 20-30℃ |
| Relative humidity (相对温度) | 35–65 %, non-condensing. For mixed media a relative humidity above 40 % is recommended, to control static effectively and protect print quality (35 - 65%, 无凝结. 对于混合材料，相对湿度建议高于40%，以有效的控制静电，保证 打图质量) |
| Maximum power (最大功率) | 8000W |
| Connection parameters (接入参数) | Input voltage: 200–240 VAC, single-phase, 50/60 Hz, 32 A × 2 (输入电压: 200 到 240 VAC, 单相, 50/60Hz, 32A x 2) |
Read from the builder's published page: www.floraprinter.com, on 2026-08-30.
Check against the machine before you buy or budget on it. Builders publish a range and a configuration; the machine on your floor may be a different variant, may have been rebuilt, and may not carry the options these figures assume. This register records what the builder published, not what any individual machine does.
Related machines
Also from Shenzhen Runtianzhi Digital
Other machines of this kind: Digital textile printing
Elsewhere in Dyeing, finishing and printing
Report incorrect information on this page
Tell us what is wrong and we will check it against the source. Reports are private, are never published, and go to an editor rather than into a comment thread.