ASTM
ASTM D2256/D2256M Standard Test Method for Tensile Properties of Yarns by the Single-Strand Method
Single-strand yarn strength and elongation — the tensile test behind most yarn specifications written to ASTM.
- Number
- ASTM D2256/D2256M
- Committee
- ASTM D13.58
- Status
- active
Verification coverage
Not yet checked: ISO, AATCC, BIS, SAC, JIS, EN, DIN — an absent row here does not mean no equivalent exists.
What this standard is for
Where it is used
Yarn purchase specifications, incoming inspection, and any argument about whether a warp will survive weaving.
Why it matters
Yarn strength predicts end breakage, and end breakage sets loom efficiency. It is the earliest number in the chain that tells a weaver what their shed is going to cost them.
What to watch for
ISO 2062 is the comparable ISO method and is already held here. Gauge length and extension rate change the answer materially, so a strength figure without both is not a figure. Single-strand and skein (lea) strength are different tests and different numbers.
Calculators that implement this
- Air-Jet & Vortex Spinning Production, Air Demand & Energy per Kilogram
- Core-Spun Yarn Core Ratio, Sheath Cover & Stretch Potential
- Fabric Weight Converter: GSM to oz/yd², Tenacity & Yarn Length
- Let-Off Torque, Warp Tension Swing & Take-Up Load
- Ring Spinning Tension, End Breakage Rate & Efficiency Loss
- Rotor Spinning Twist, Peripheral Speed & Production Window
- Shed Geometry, Warp Strain & Abrasion Exposure
- Siro Spinning Strand Spacing, Convergence Angle & Twist Balance
- Sized Yarn Abrasion Resistance, Hairiness Gain & Add-On Adequacy
- Warping Machine Production & Beam Capacity Calculator
- Yarn Splice Strength Retention, Bulk & Weakest-Splice Risk
- Yarn Strength Distribution, Weak Place & Safety Factor
Buy the official copy from ASTM
Metadata only — purchase the standard from the issuing body.
Report incorrect information on this page
Tell us what is wrong and we will check it against the source. Reports are private, are never published, and go to an editor rather than into a comment thread.