Fully automatic fabric spreading machine for thin, soft fabrics such as knits and underwear. A vibrating conveyor reduces the lengthwise wrinkles that form during selvedge alignment and lowers the tension on the fabric. A tension (potentiometer) bar reads the fabric tension automatically so the fabric feeds out steadily. It has a colour LCD panel, a newly developed cutter unit with a fabric hold-down, and memory for up to 100 spreading settings.
Spreading machineGarment makingIn the builder's current range
Key specifications
4 of 4 key figures recorded
Specification
| Parameter | Value | Unit | Comparable |
|---|---|---|---|
| Maximum effective fabric width (KMS-1800SV5-VC) | 1800 | mm | |
| Maximum effective fabric width (KMS-2000SV5-VC) | 2000 | mm | |
| Maximum effective fabric width (KMS-2200SV5-VC) | 2200 | mm | |
| Table width (KMS-1800SV5-VC) | 2030 | mm | |
| Table width (KMS-2000SV5-VC) | 2230 | mm | |
| Table width (KMS-2200SV5-VC) | 2430 | mm | |
| Maximum stack height (one direction) | 160 | mm | |
| Maximum fabric roll diameter | 400 | mm | |
| Maximum fabric roll weight | 60 | kg | |
| Spreading speed | 70 | m/min | |
| Voltage (single-phase) | 200 | V | |
| Power consumption | 1500 | w | 1.5 kW |
| Machine dimensions L×W×H (KMS-2200SV5-VC) | 2940(L)×1755(W)×635(H) | mm | |
| Weight (KMS-2200SV5-VC) | 400 | kg |
Read from the builder's published page: www.hashima.co.jp, on 2026-11-07.
Check against the machine before you buy or budget on it. Builders publish a range and a configuration; the machine on your floor may be a different variant, may have been rebuilt, and may not carry the options these figures assume. This register records what the builder published, not what any individual machine does.
The record
- Read from
- www.hashima.co.jp,
- Checked by
- Textile School,
- Last changed
Related machines
Also from Hashima
Other machines of this kind: Spreading machine
Report incorrect information on this page
Tell us what is wrong and we will check it against the source. Reports are private, are never published, and go to an editor rather than into a comment thread.